Winteriser

3 Ltr

Fi-CLOR Winteriser has been specially developed to help prevent algae and fungi when the pool is shut down for the winter. It can also help prevent the formation of scale and staining from dissolved minerals so the water and pool surfaces are in good order when the pool is re-opened in spring. It is compatible with all sanitisers, and will not affect the pH.

  • Prevents the formation of scale and staining from disolved minerals
  • Contains long life algicides


DO NOT MIX WITH OTHER PRODUCTS.
DO NOT DILUTE BEFORE USE.



Instructions

Calculate the volume of water in the pool using our handy pool water calculator.

If you have not decommissioned your pool for the winter before, the guidelines on this pack should be of some assistance. If you are in any doubt as to your ability, call in your local pool centre or service engineer to do the job for you.

  1. Thoroughly backwash the filter. Remove any debris from the pump strainer, skimmers and pool water surface.

  2. Shock dose with a stabiliser-free chlorine such as Fi-Clor Superfast Shock to kill any algae and harmful organisms that may be present. (If your pool is treated with a non-chlorine sanitiser - PHMB, treat with Baquacil Winteriser). Allow the water to circulate for 3 - 4 hours to ensure thorough mixing.

  3. Close the valve/s from the skimmer/s and lower the water to 5 - 7cm below the skimmer level. (Do not lower the water level too much).

  4. With the water still circulating via the bottom drain, add Fi-Clor Winteriser, leaving the circulation running long enough to ensure thorough mixing.

  5. Remove ladders, diving boards and summer covers and store them away from extremes of temperature.

  6. Switch off and isolate the electricity supply.

  7. Drain the water from the pump, filter and heater taking care to retain any 'O' rings from unions.

  8. Disconnect the pump and store in a dry place away from extremesof temperature.

  9. Leave valves above water level open, those below should be closed and protected against frost damage.

  10. Using strong cord or thin rope, float several weighted and sealed polythene bottles (perhaps used 5kg chemical containers). Space these evenly down the length of the pool to absorb expansion of ice.

  11. Cover the pool with a heavy duty winter pool cover.

  12. Check the appearance of the water, and the pH and free chlorine occasionally while the pool is shut down. If the winter is mild, add another dose of Winteriser in February.



Warning
: Do not use together with other products. May release dangerous gases (chlorine).

Precautions: Never mix chemicals, except by dosing into the pool separately and at different times. Never add chemicals to the water when bathers are in the pool. Store in a cool, dry, well ventilated, secure place away from oxidising and reducing agents, eg, petrol, oil, solvents and organic materials; ammonia, fertiliser and nitrogen compounds; strong acids and alkalis. Avoid direct contact with pool chemicals. Should there be skin contact with chemicals, wash thoroughly.

Disposal When empty and providing it has been rinsed out on the pool. this container may be disposed of via household recycling.

[ Top ]

‹ First page

|

‹ Previous page